Skip to main content
Submitted by eurot on Mon, 07/17/2017 - 13:45

Hello.

We have the DMC-41x3 , I have used the software to set the limits for the motors.

Is it possible to have automation like CNC with this software/device?,
Do I need the full software package?

Thanks

Comments 1

KushalP on 07/24/2017 - 08:38

Hi eurot,

The full version of Galil Suite would provide access to the Scope and Tuner. This would allow you to have real time monitoring of all of the controller's parameters. Allowing you to plot the velocity, acceleration and much more. For new applications we recommend using GDK and not our older Galil Suite software. GDK will allow you to program the motion for your controller as well. If however you are looking for a full CNC interface where you can import DXF drawings and run a mill, I would recommend using either the Camsoft or Mach 3/4 software.