Skip to main content
Submitted by andrebarcay on Sun, 04/26/2015 - 21:36

Hello,

I am trying to configure a master slave setup with the B axis as the master and the Dd axis as the slave. Somehow, I set the A xis to use the N axis as the master and I can't remove it in the configuration window. I have tried to set it to 0 but it just automatically reverts back to N. I there a trick that I'm missing?

Attached is a text file of the backup configuration.

Thanks,
Andre Barclay

Comments 1

rogerp on 04/27/2015 - 13:21

Andre,

After reviewing the GA command reference and doing some experimentation, it appears that GA cannot be cleared out once set. This behavior should have no effect on the system, since gearing is turned off by the command GR0.

http://www.galil.com/download/comref/comall/index.html#master_axis_for_…

If you are determined to clear this parameter out, you could perform a master reset then remove the line from your backup configuration file.

Best,